WOOD GLUE

Product Details

A water based wood glue based on polyvinyl acetate polymer, designed with excellent high tack and bond strength ,developed for various wood carpentry application uses , such as :[ bonding timber, MDF, doors, windows in high speed assembly lines at joineries]

Product is not suitable for perpetual wet areas like toilets, kitchen sink etc.,

Virtues: It is a nontoxic and non-flammable water based, environmental friendly single component product.

USE

Product is also useful for decorative bonding, cold and hot pressing of decorative laminates, wood veneers to ply, block boards, tiles in dry condition. Etc.

SPECIFICATIONS

Properties

Color : milky white

Specific gravity : 1.01 Kg/lit [± 0.025]

Viscosity 4/25°C : 220 sec. [± 1]

Weight Solids : 38% Kg/Kg [± 1]

PH : 5-7

Drying Interval

Open Tack : 5-10 min.

Curing : 60 hrs. [Temperature, humidity, air movement, film thickness and

number of coats all affect the drying time.]

APPLICATION RATE : 80gr/m²

SURFACE PREPARATION

All timber species must be fully aged with a moisture content of less than 15%. Surface must be dry, clean and free from contaminations. Natural oil or gum must be removed by solvent cleaning.

Exclusions for successful application include perpetually wet surfaces and also large cavities on

wood surfaces.

WOOD GLUE Product No. PW1613

This information contained in the data sheet is to the best of our knowledge correct and up to date. Under well-defined conditions. Its accuracy or suitability under the

actual conditions of any independent use is not guaranteed and must be determined by the user. All advice given about this product is given in good faith. Since as we

have no control over conditions of substrate and application, manufacturer and seller cannot accept any liability in connection with the use of the product relative to

coverage, performance, injury, or damage, unless we specify in writing to do so. The information in this data sheet is subject to change without prior notice and it is the

user responsibility to ensure it is current. For further information and advice please contact RITVER Technical Service Department.

Date Revised: 01st Jan 2012 2

APPLICATION METHODS

RITVER Wood glue is generally recommended to be applied without any thinning and as such.

During application use a mechanical glue spreader or a convenient spatula. Ensure that the

surface is free from dust and oil moieties. Spread the adhesive evenly and leave it for 5 to 10

minutes as per the wood surfaces. Press the surface to be bonded and squeeze out the excess.

Remove the non-dried portion with warm water or resort to mechanical removal when dry.

Do not apply when wet as there will be no bondage to the substrate.

Once used keep the container closed immediately. It is also important to see that the tools used

for application is cleaned before the glue dries off.

PRODUCT PREPARATION

Stir well before use. Thin to the required viscosity ensuring the product is homogeneous.

Dilution

By brush, roller

Normally ready to use but we can dilute the product up to 15 % by water.

SUBSEQUENT TREATMENT

After drying this product, it does not need any subsequent treatment.

PACKING & STORING

Available in 1Lit, 4Lit ,20Lit and 200Lit .

Store in a cool and well ventilated place. Keep away from direct sunlight. Minimum one year in unopened container, stored in a cool and dry condition at 25°C.

SAFETY & FLAMMABLE

Do not expose product to direct sun light.

In case of contact with eyes rinse immediately with plenty of sweet water and seek medical

Keep away from sources of ignition. Keep out of reach of children