Port | DUBAI |
Packaging | 1LTR 12 PCS IN CTNS/4LTRS 4 IN A CTN AND 18LTRS |
Lead Time | 3 DAYS |
Ritver Red Oxide Primer is based on Alkyd resin containing anticorrosive pigments. It is used
as a primer coat for many applications especially for protecting the metals and other steel
structures against corrosion and is quite versatile. It forms a firm base with good adhesion for
Ritver Topcoat enamels and Ritver Quick drying enamels.
USE
Substrates: Metals and Steel
Area of Use: Interiors and Exteriors.
SPECIFICATIONS
Properties
Finish : Matt/smooth.
Colour : Red/Grey
Specific gravity : 1.5+/-.005
Mixed Solids (% by volume) : 54 2
Diluent : Xylene.
Flash point : 27°c
Spread Rate:
While the spread rate is directly dependant on the surface profile and also the type of
undulations it has, as a thumb rule Ritver Red Oxide Primer would cover 9 – 10 meters per
lit.
Drying Time (30° C) : Set to touch: 2 – 3 hours.
: Ready for Recoat: app 6 – 8 hours.
Recommended DFT : 1 mist coat followed by a good full coat.
App 35 - 40 mic.
SURFACE PREPARATION
A good surface preparation and following the method statement / recommended system
procedure of Ritver is an ideal recommendation for the application of Ritver Red Oxide
Primer
For Metals & Steel Surfaces:
Achieve a good and clean surface by removing all contaminants by cleaning & drying. A laitance
free surface should be achieved by good sweep blast or a wire brush. Apply one coat of Ritver
Red Oxide Primer and proceed after drying
Apply one good coat or two nominal coats with a spray or a suitable roller and obtain the
desired coverage.
Exclusions for successful application include perpetually wet surfaces and also large cavities on
wood, metal or concrete surfaces.
RED OXIDE PRIMER Product No. PS1301
This information contained in the data sheet is to the best of our knowledge correct and up to date. Under well-defined conditions. Its accuracy or suitability under
the actual conditions of any independent use is not guaranteed and must be determined by the user. All advice given about this product is given in good faith. Since
as we have no control over conditions of substrate and application, manufacturer and seller cannot accept any liability in connection with the use of the product
relative to coverage, performance, injury, or damage, unless we specify in writing to do so. The information in this data sheet is subject to change without prior
notice and it is the user responsibility to ensure it is current. For further information and advice please contact RITVER Technical Service Department.
Date Revised: 01 Jan 2019