SYNTON-TECH - Metal Oxide Film Resistor (MO)

Product Details

METAL OXIDE FILM RESISTOR

MO (FLAME-PROOF COATING TYPE)

♦INTRODUCTION
Liquid SnCI 4 heated to 400～700℃ and sprayed on ceramic rod to make it a thin film on the surface of rod.
Then SbCI 3 added to make it acid film. As the film is strong metal oxided, it will last for years with very little change of resistance. SYNTON-TECH’s MO series are especially suitable for the requirements of large load or high temperature operation.

♦FEATURES
-Excellent long-term stability and reliability!
-Met MIL-R-22684B requirements!
-Extremely low for annual shift!
-Excellent flame retardant coating with “ Freon ” resistant performance!
-Can produce high resistance value to replace wire wound resistor with lower cost!
-Tolerance available: ±5%, ±2%, ±1%
-Voltage available: 1/8W, 1/4W, 1/2W, 1W, 2W, 3W, 4W, 5W, 7W, 10W
-Based on application concerns, MO rods can be replaces by CR or MF rods.

SPECIFICATION：https://tw.synton-tech.com/upload/1533714451.pdf

Liquid SnCI 4 heated 400~700℃ and sprayed on ceramic rod and became a thin film on the surface of rod. Then SbCI 3 added to make it acid film. As the film is strong metal oxided, it will last for years with very little change of resistance. SYNTON-TECH's MO series are especially fit for the requirements of large load or high temperature operation.

Official website: https://en.synton.com.tw/
Contact number: (02) 2698-1011
Contact email: [email protected]