METAL FILM FIXED RESISTOR
MF (EPOXY COATING TYPE)
♦INTRODUCTION
To fill the function gap of carbon
film resistors, metal oxide film resistors or wire wound
resistors so that SYNTON-TECH makes metal film resistors. The
resistive element is a high contests of AL203 ceramic rod on
which a thin film of Ni/Cr alloy is deposited by vacuum
sputtering system. Then contact caps are pressed onto the ends of
the rod and a helical groove cut through the film to give the
required resistance value.
Connecting copper wire are welded
to the end caps. Finally the resistors are coated with multiple
layers of Insulation lacquer. SYNTON-TECH’s MF series are
suitable for all circuit applications especially tighter
tolerance and low temperature coefficient are
required.
♦FEATURES
-Met American military
specification MIL-R-10509F!
-Very low currect
noise!
-Board selection of temperature
coefficient: ±100ppm, ±50ppm, ±25ppm, ±15ppm, ±10ppm/℃
-Tolerance available: ±5%, ±2%,
±1%, ±0.5%, ±0.25%, ±0.1%, ±0.05%, ±0.01%
-Voltage available: 1/16W, 1/8W,
1/6W, 1/3W, 1/4W, 0.4W, 1/2W, 0.6W, 1W, 2W, 3W
-Major applications are switching
power supplies, communication equipments, monitors, testing
meters.
SPECIFICATION:https://tw.synton-tech.com/upload/1533714629.pdf
To fill the function gap of carbon film fixed resistors, metal oxide film resistors or wirewound resistors. The resistive element is a high contests of AL203 ceramic rod on which a thin film of Ni/Cr alloy is deposited by vacuum sputtering system. Then contact caps are pressed onto the ends of the rod and a helical groove cut through the film to give the required resistance value.
Official website:
https://en.synton.com.tw/
Contact number: (02) 2698-1011
Contact email: [email protected]
Add: 16F-3, No 79, Far East World Center Sec. 1, Hsin Tai Wu Rd, Hsi-Chih Dist.