GE Optima XR220amx
GE Optima XR220amx Features
The Optima XR220amx is a self-contained battery operated mobile
radiographic digital X-Ray imaging system designed for performing
radiographic exams at the point of care when it is not safe or
practical to move the patient to the radiographic room.
Optima XR220amx is suited for routine radiographic procedures
within a hospital including radiology departments, intensive care
units, cardiac care units, emergency departments, operating
rooms, orthopedics, pediatrics, hospital rooms and clinics.
FlashPad Lightweight detector designed for
mobile use, weighs less than 4.5 kg (10 lbs.) including
battery
“Stand-by” mode eliminates boot up cycles and
allows exposure within 25 seconds
Designed for 24/7 availability. Use with
battery or make and process exposures while the unit is
charging
Detector can support up to 160 Kg (352 lbs.)
of distributed load for bariatric applications
Detector battery charges automatically while
the detector is in the bin
Automatic charging algorithms allow the system
to be re-charged even if batteries are not fully drained
15kW (nominal) generator and available
30kW(nominal) option
GE Optima XR220amx Specifications
Wireless Digital Detector
Detector battery can take up to 50 exposures
per hour and provide enough power for 3 hours of use on a single
charge
Single panel (non-tiled) amorphous silicon
detector with a Cesium Iodide scintillator
Image area: 40.4 cm x 40.4 cm (15.9 in x15.9
in)
Active matrix: 2024 x 2024 pixels
Pixel Pitch: 200 microns
Typical upper dynamic range: 7.8mR
Typical DQE: @ 0lp/mm: 68%)
Two handgrips
Detector Environmental Conditions
Temperature
Operating: 15°C to 35°C
Non-Operating: -0°C to 50°C (maximum change
20°C per hour)
Humidity
Operating: 10% to 80% RH, noncondensing(max.
change 30% per hour)
Non-Operating: 10% to 95% RH, noncondensing
(max. change 30% per hour)
Power
Capable of 100-240 V nominal, 50/60 Hz
operation
System battery status display
X-Ray Source
Nominal Tube Voltage (Radiographic) 40 ~ 150
kV
Nominal Focal Spot size (IEC 60336):
Large Focus: 1.2
mm
Small Focus: 0.6
mm
Anode Rotation Speed (minimal): 3200 min-1
Permanent Filtration: 0.9 mm Al/75 kV
IEC60522: 1999
Maximum X-ray Tube Current
Large Focus: 500
mA
Small Focus: 200
mA
Maximum Continuous Heat Dissipation: Without
Air-circulator: 170 W (238 HU/s)
Maximum anode heat units: 140 kHU
Exposure time: 4.0 msec – 6.0 sec