MOQ | 1 Piece |
Condition | New | Quality | Best |
Feature | Using Permanent Magnet |
Model | Applied wire diamiter(mm) | Tension scope(g) |
MTQ-30 | φ0.02-φ0.06 | 3-30 |
MTQ-100 | φ0.04-φ0.12 | 10-100 |
MTQ-200 | φ0.06-φ0.16 | 20-200 |
MTQ-400 | φ0.08-φ0.25 | 50-400 |
MTQ-600 | φ0.12φ-0.35 | 80-600 |
MTQ-800 | φ0.14-φ0.40 | 100-800 |
MTQ-1200 | φ0.20-φ0.50 | 200-1200 |
Product
feature
1.Please read the product instruction carefully before
using.
2.Working pressure: 5kg/cm2
3.If not use for a long time, when the damping wheel jitter,
before starting please turn to the degaussing process: first
close wise and then counterclockwise to adjust tension from
maximum to minimum to complete the degaussing.
4.When debugging, first adjust the tension to the scale
position, and then adjust the Anti-back tension adjustment
knob to make the tension rod under the green logo (slightly
lower than level state)
5.The reason for the tesion:
1) The wool pre-tension is not enough which need
adjusted.
2) The O-ring and the wool felt is dirty, need to be cleaned
or replaced.
6.During normal working, the tension can be adjusted from
small to large (clockwise). But from large to small
(conterclosewise) is prohibited. Otherwise may cause
breakage.
When replace wool felt please follow the original thickness
and size, otherwise will lead to the unsmooth of the wire
winding.
Note:
1.Please reading
the product instruction carefully before using;
2.If long time without using. When the damping wheel jitter,
before starting please turning to degaussing process first
clockwise and then counterclockwise tension adjuster to
adjust the maximum to the minimum to complete the
degaussing.
3.When debugging, first adjust the tension to the scale
position, and then adjust the Anti-back tension, adjustment
knob makes the tension rod under the green logo(slightly
lower than the level state)
4.The reason for the tension can't adjust:
Hang line diagram
1)The wool pre-tighten is not enough need to be adjust
it;
2)The O-Ring and the wool felt is too dirty need to be clean
ot replace.
5.Normally working the tension can be adjusted from small to
large (clockwise), prohibit the tension by major to small
(counterclockwise), otherwise cause breakage.
6.When replace Wool felt please according to the thickness
and size with the factory, or it will cause the wire not
smoothly.
Product
Picture
email:[email protected]
mobile
phone:86-17896495846