Lithium Ion Battery
Good performance under high and low temperature;
Good safety performance;
Good cycle life time;
No pollution during manufacture.
Application:
Electric
vehicle
Golf
cart
Electric
motorcycle
Electric
boat
Electric
forklift
Telecommunication
Distributed Grid
Energy Storage system
Mining
equipment
Solar energy
storage system
Marine
Backup
power
Household energy
storage system
Certifications
Specification
of battery
cell
Basic
Performance
(1) Output with
high
magnification:
Standard discharge current is
0.5C-1.0C,
instant impulse discharge current is 10C
for
2
seconds.
(2) Good performance
under high temperature, it could work under 65°C
temperature.The battery structure is safe and
good.
(3) Good performance
under low
temperature,
discharge
capacity
in no less
than
90%
of rated capacity when
discharging with
1C
under
-20°C;
no less than
70%
of rated capacity with
0.33C.
(4) Good safety
performance:When the pressure inside the battery is too large,
the one-way safety valve will release gas and heat to make sure
battery perform well. When the internal pressure reaches a
certain level, the valve will be open immediately which can
protect the battery from burning and
explosion.
(5) Good cycle life
time, the discharge capacity is still over 80% after 3000 cycle
times of single
cell
(80%DOD).
(6) It can fast
charging. It could be charged to 80% within 0.5h and charged
full with
1h.
(7) Low
cost.
(8)
No pollution during manufacture and
usage.
Matters Needing
Attention
(1) Please check if
spare parts are completed when open the package and read the
operation manual
carefully.
(2) Do not make the
battery Short Circuit,do not over charge and
discharge.
(3) Please charge the
new battery to full capacity before discharge for the first
use.
(4) The battery pack
is fixed with plate and strip before delivery, do not
disassemble the plate and strip when
using
the
battery.
(5) Checking the
voltage of battery, normally it is
3.2V-3.3V.
(6) Fix BMS for
battery pack and protect single cell to avoid over charge and
over-discharge.
(7) Rivet or screw is
used for battery
connector.
(8) Please use copper
part to connect battery packs and fix with hydraulic
pressure
plier.
We could also provide the
relevant
connection which fixed
with
screws.
(9) The charger used
should be approved by our company in order to match with our
lithium
batteries.
(10) It will shorten
battery cycle lifetime and damage battery due to overcharge and
over-discharge if not do
according
to the above. It wont
be within our company
warranty.
Requirement for
safety
assurance
For the sake of safety
assurance, please discuss the equipment design, its system and
protection circuit of Lithium-ion cell advance. And consult
about the high rate current, rapid charge and special
application in the same
way.
Welcome your
inquiries or
mails.