Model NO. | GBS-LFP60Ah | Installation | Packaged |
Rechargeable | Chargeable | Weight | 2kg |
Rated Capacity | 60ah | Cycle Life | 3000 Cycles |
Transport Package | Special Carton for Dangerous Goods | Specification | 125*65*190mm |
Trademark | GBSystem | Origin | China |
HS Code | 8507600090 | Production Capacity | 1600000 |
Good safety performance;
Good cycle life time;
No pollution during manufacture.
Application:
Electric
vehicle
Golf
cart
Electric
motorcycle
Electric
boat
Electric
forklift
Telecommunication
Distributed Grid
Energy Storage system
Mining
equipment
Solar energy
storage system
Marine
Backup
power
Household energy
storage system
Specification
of battery
cell
Basic
Performance
(1) Output with
high
magnification:
Standard discharge current is
0.5C-1.0C,
instant impulse discharge current is 10C
for
2
seconds.
(2) Good performance
under high temperature, it could work under 65°C
temperature.The battery structure is safe and
good.
(3) Good performance
under low
temperature,
discharge
capacity
in no less
than
90%
of rated capacity
when discharging with
1C
under
-20°C;
no less than
70%
of rated capacity
with
0.33C.
(4) Good safety
performance:When the pressure inside the battery is too
large, the one-way safety valve will release gas and heat to
make sure battery perform well. When the internal pressure
reaches a certain level, the valve will be open immediately
which can protect the battery from burning and
explosion.
(5) Good cycle life
time, the discharge capacity is still over 80% after 3000
cycle times of single
cell
(80%DOD).
(6) It can fast
charging. It could be charged to 80% within 0.5h and charged
full with
1h.
(7) Low
cost.
(8)
No pollution during manufacture and
usage.
(1) Please check if
spare parts are completed when open the package and read the
operation manual
carefully.
(2) Do not make the
battery Short Circuit,do not over charge and
discharge.
(3) Please charge
the new battery to full capacity before discharge for the
first
use.
(4) The battery pack
is fixed with plate and strip before delivery, do not
disassemble the plate and strip when
using
the
battery.
(5) Checking the
voltage of battery, normally it is
3.2V-3.3V.
(6) Fix BMS for
battery pack and protect single cell to avoid over charge and
over-discharge.
(7) Rivet or screw
is used for battery
connector.
(8) Please use
copper part to connect battery packs and fix with hydraulic
pressure
plier.
We could also provide the
relevant
connection which
fixed with
screws.
(9) The charger used
should be approved by our company in order to match with our
lithium
batteries.
(10) It will shorten
battery cycle lifetime and damage battery due to overcharge
and over-discharge if not do
according
to the above. It
wont be within our company
warranty.
Requirement for
safety
assurance
For the sake of
safety assurance, please discuss the equipment design, its
system and protection circuit of Lithium-ion cell advance.
And consult about the high rate current, rapid charge and
special application in the same
way.
Welcome your inquiries or
mails.