INR18650-1500mAh Battery,1500mAh Li-ion cylindrical battery

MOQ	2000 PCS
Port	SHANGHAI
Packaging	CARTON BOX
Lead Time	30-45DAYS

Contact Now

Product Details

INR18650-1500mAh Battery,1500mAh Li-ion cylindrical battery,lithium ion battery,cylindrical power lithium-ion batteries

1500mAh Li-ion battery Product Details:

NO.	Items		Specifications
1	Model		INR18650-1500
2	Can Material		Ni-Iron
3	Rated Capacity		1500 mAh（0.2C5A）
4	Nominal Voltage		3.7V
5	Max. Charge Voltage		4.2 V
6	Discharge Cut-off Voltage		2.75V
7	Max. Charge Current		1 C5A
8	Max. Continuous Discharge Current		20 A
9	Max. Pulse Discharge Current		30A（ 2s pulse ）
10	Max. Diameter（include PVC）		≤18.30 mm
11	Max. Height (include PVC)		≤65.30mm
12	Weight (Approx.)		43.0g
13	Impedance （Max. at 1000Hz、charged status）		≤ 20 mΩ
14	Charge Method (CC/CV)	Standard	0.5 C5A×3hrs
		Quick	1 C5A×2.5hrs.
15	Operating Temperature	Charge	0℃～45℃ 32oF～113oF
		Discharge	-10℃～60℃ -4oF～140oF
		Storage	-20℃～45℃ -4oF～113oF

Characteristic of High security rechargeable lithium battery

Without special instructions, the following tests should be done under the condition of : temperature(23℃±3℃), atmospheric pressure (86KPa～106KPa), relative humidity (45%～85%), and the tests should be done within two weeks after receiving the products.

the definitions of some nomenclatures of this specification

standard Charge: Charge with current 0.2C5A to limit charge voltage under the condition of23℃±3℃

surrounding temperature,then change to charge with constant voltage till the current less than or equal to0.02C5A.

Electrical Characteristic for Long life lithium ion battery

NO.	Item	Standard	Test Method
1	Discharge rate capabilities	A）1 C5A ≥100% B）10 C5A ≥95% C）15 C5A ≥90%	Standard charged under the condition of normal atmospheric pressure and the environmental temperature of 23℃±3℃ and45%～85%RH, then rest for 30mins and discharge at1C5A、5 C5A、10 C5A to the discharge cut-off voltage respectively. Charge/discharge cycle can be conducted for 3times before meeting the Standards（the same below）
2	capacity retention and recovery	Residualcapacity≥94％ Recoverablecapacity≥*98％	Standard charged under the condition of normal atmospheric pressure and the environmental temperature of 23℃±3℃， Stored for 28 days, then discharge at 0.2 C5A to 2.75Vmeasuring residual capacity; Then standard charge/discharge measure recoverable capacity.
3	Low Temperature Performance	discharge capacity≥85% rated capacityno distortion and no rupture	The cell shall be charged in accordance with the standard charge. Then stored in the temperature of -10℃±1℃ for4h, Discharge at the constant current of 0.2C5A down to the end-of-discharge voltage 2.75V.
4	Cycle Life	≥300cycles	Charge: The cell shall be charged in accordance with RapidCharge condition. rest for 10mins.Discharge: 10C5A discharge to 2.75V, one cycle is finished, then rest for 30mins. Then repeat above steps, when capacity is less than 80% of initial capacity, the battery life is over.

Safety Characteristic of High temperature resistance lithium ion battery

NO.	Item	Standard	Test Method
1	Overcharge	No fire、No explosion	After standard charge, rest for 10mins; then charge at constant current of 3C5A to 10V.(or charge at 3C5A for 90mins).
2	Forced discharge	No fire、No explosion	The battery to be discharged with standard discharging condition, Inverse charge current =1C5A；time: ≥ 90mins
3	Short Circuit test	No fire、 No explosion	The battery to be fully charged with standard charging condition, and short the positive and negative terminals with wire resistance ≤50mΩ.Tests are to be conducted at 23℃±3℃ and at 55℃ ±5℃, keep 24h or case temperature decline to 20% of the max temperature ,test is over.
4	Crush test	No fire、No explosion	A battery is crushed between two flat surfaces. The applied force is 13 kN±1kN by hydrocylinder, Once the maximum pressure has been obtained or voltage decrease to 1/3 of nominal voltage sharply, then release pressure.
5	Shock test	No fire、No explosion	The full charged battery is fixed on shock table, to force a certain shock to three mutual vertical direction, in initial 3ms, the min. average acceleration is 75gn,the peak acceleration is between 125gn and 175gn.
6	Heating test (130°C)	No fire、No explosion	The cells are fully charged with standard charging condition, and put into incubator with nature air or cycled air convected, heat battery by velocity of 5°C ±2°C/min to 130°C±2°C,and maintain for 10mins.
7	Temperature Cycling Test	no leakage, no fire, no explosion	The fully charged batteries are placed in a test chamber and subjected to the following cycles: a) Raising the temperature to 75°C ±2°C within 30 minutes and maintaining this temperature for 6 hours. b) Reducing the temperature to minus 40°C ±2°C within 30 minutes and maintaining this temperature for 6 hours. c) Repeating the sequence for a further 9 cycles. d) After the 10th cycle, storing the batteries for 24 hours prior to examination.