1- Work on a flat surface where uniform heat and pressure
can be applied. Avoid applying film over seams and
stitches.
2- Remove adhesive side line (if that product has one),
exposing dry adhesive. Do not remove reflective side
liner.
3- Place YillumaxTM
Reflective Material - Transfer Film on substrate with the
adhesive side down and apply heat and pressure as described
in the table below. Place a non-stick slip sheet between
the platen and laminating surface to prevent any excess
adhesive transfer contamination.
4- Allow application to cool to room temperature before
removing the liner covering the reflective side (if that
product has one).
Place application on a flat surface and remove the liner by
lifting one corner and pulling (about 45o angle) in a
continuous, smooth manner.