Yillumax™ Reflective Material Hazard Obstacle Warning
Family Vehicle Delineator Conspicuity Markings VGP7950
Series material must be applied when the air and surface
temperature is between 20° C and 38° C to assure proper
adhesive bonding. Surfaces must be cleaned for all grease,
oil and dirt. Use a clean towel and Isopropyl alcohol or
similar to wipe the surface before application. If any air
bubbles are trapped, use a pin to puncture the bubble and
squeegee to push the air towards the pin hole.
Adhesive
YillumaxTM
Reflective Material Hazard Obstacle Warning Family Vehicle
Delineator Conspicuity Markings VGP7950 Series has a
pressure-sensitive adhesive that is recommended for
application at temperatures of 65° F (18° C) or
higher.
Maintenance
Cleaning
Routine washing is recommended for maximum performance.
The following cleaning methods are recommended.
* Wash with sponge, cloth or soft brush using water and
detergent.
* Automatic truck/car wash or standard high-pressure hand
spray:
Maximum pressure-1200 PSI/ 80 bar.
Maximum water/wash solution temperature- 140°F/
60°C.
Minimum of 12 inches/ 30cm distance of cleaning jet(s)
from markings.
Cleaning wand or jets to be at no greater angle than 45
degrees from perpendicular to the marking
surface.
* When using metal brighteners, follow manufacturer’s
recommendations for dilution. Thoroughly rinse from
markings after soaking Trains.
Storage
* Cool, dry area out of direct sunlight.
* Temperature 65-75°F (18-24°C) humidity
30-50%.
* Store rolls horizontally, in carton or in original
packaging.
Shelf Life
* Apply Yillumax™ Reflective Material – Hazard Obstacle
Warning Family Vehicle Delineator Conspicuity Markings
VGP7950 Series within two years of receipt of
material.
General Performance Considerations
Yillumax™ Reflective Material – Hazard Obstacle Warning
Family Vehicle Delineator Conspicuity Markings VGP7950
Series will provide maximum durability when:
* Recommended procedures are followed.
* Marking is applied to vertical surfaces.
Actual durability will be based on actual customer use,
field testing, exterior exposed testing and artificial
weathering testing.
Durability can be reduced if recommended techniques are
not followed:
* Failure to cut markings around rivets, seams and body
are panels.
* Improper use of high-pressure cleaning.
* Spillage of chemicals or solvents.
* Improper application or surface
preparation.