Port | shanghai port |
Packaging | well packed in wood boxes |
Lead Time | 7days |
1.Tensile strength :Rm 600Mpa Yield/tensile ratio:0.85-0.90
2.Copper thickness: H 0.254mm
3.Plasticity of copper layer: When the product is bent at 90° there's no crack in the inner and outer edge copper layer.
4.Copper layer bondability: When the product is placed between the clamp or the vise jaws, the spacing is smaller than the diameter of the sample steel core(W=d-0.1),hammer the end of the sample, cut off enough copper layer, fully expose the steel core, the exfoliated copper layer is allowed at the jaws of vise, however the remaining part of rod, exfoliated copper and steel is not allowed to be visible to the naked eye.
5.Electrical-corrosion
performance:Simulated fault current releasing, after the
electrical-corrosion cycle test, the final resistance value
growth rate does not exceed 50% of the initial resistance value,
Morever, the resistance growth rate of each test step does not
exceed 15% during the testing process, And the surface of the
copper bonded steel sample is completed, without cracks,
pits,bubbling defects after the test.
Performance testing and matching requirements
In terms of copper bonded steel product application technology, by analyzing IEEE837, IEC62561-2, UL467 and other standards, Sunlight experimental center is equipped with test equipments for all testing, including mechanical testing ,electrical testing, corrosion testing ,ect., for product development and production quality control.
(you can see in the above video image: copper bonded steel produced by other manufacturer cannot pass the fault current test, once the current flows, it melts )
1,Copper bonded steel tape coil with a single 100-meter roll( also provide 40-meter, 60-meter, 80-meter roll,etc.,100% suit for market requirements) can be widely used in power plants,substations, petrochemical projects, etc,.
2,Meet the requirements of grounding resistance and potential difference in the grounding system when used in large-scale grounding grid.
3,Reduce direct material cost of the connection joint by 90% and labor cost (eg: The grounding material is laid in a grounding groove with a length of 100 meters, if a single 100-meter copper bonded coil is used, only one connection joint is required, while using a copper bonded steel rod with a length of 6 meters, 16 joints(not including both ends) should be required)
No. 888, Konggang 2nd road, Shuangliu, Chengdu, Sichuan Province, China