Best Quality PSA Oxygen Gas Generator Equipment

Best Quality PSA Oxygen Gas Generator Equipment is one kind of oxygen generator suitable for use in workshop where need oxygen for metal cutting.  For many metal cutting applications, cylinder hold oxygen is often used. But to achieve oxygen filling into cylinder, high pressure oxygen compressor and filling station is needed, which increase the investment cost a lot. In order to reduce the investment cost, Gamma developed out this 99% purity industrial oxygen generator, it supplies 5 bars oxygen into one oxygen storage tank. When the pressure inside the tank is smaller than certain degree, the machne start to run again.  In this way, there is no need for oxygen compressor and no need for oxygen cylinder.

This oxygen generator adapts PSA technology, produce oxygen from air. It use air compressor as raw material supplier, use three filters, one dryer and one oil remover to get rid of impurities from the compressed air . Then the treated air goes into one air tank to stablize pressure and flow rate. Then the compressed air enters one oxygen separator, this is the key part for oxygen equipment. After air pass through this part, high purity oxygen (93%) is collected. The collected air is sent to one buffer tank then send to industrial applications. c.

After sales service

Free customer site installation guidance, free training for operation and maintenance. No need to pay for Gamma engineer's site service.

One years operation warranty. Should any trouble happened, Gamma provide and send parts free of charge. If necessary, Gamma engineer comes to site at our own cost.