30m Cement Mortar Spraying / Cement mortar Plastering Machine

Product Description

          Mortar spraying machine and grouting machine suitable for: indoor and outdoor ceiling spray, expansion joints leaking, sinking leaking, subway leakage, tunnel leakage, mine plugging, air defense plugging works, dam leakage plugging, floor, cracks, Drum reinforcement, cement mortar spraying, dry mortar spraying, waterproof grouting and waterproof surface coating, waterproof spraying, grouting, ceiling spray, wall spraying, paint spraying, garden spraying, relief effect paint spraying, handicraft spraying, latex paint Paint, rockery spray, sculpture spray can be, sound-absorbing material spray.

Product Operation:

1. Turn on the power, press the button, the screw pump that is working. If you turn the reverse, press the stop button to stop.

2. In the delivery hose into the injection of a small amount of water, or with a screw pump water wet delivery hose, and then the tube of water gradually discharged from the export. Drainage should be clean, the tube shall not be retained

3. Connect the duct to the mortar tube side by side. The air duct is connected to the gun.

4. Stir the material into the hopper (can be used with the powder machine).

5. Press the start button to start the shot. In the work, combined with the regulation of air volume, can make the best spray quality.

6. Adjustable speed of the screw pump, the output flow of 0-8 liters / min, at work, as long as the return to adjust the requirements to the construction requirements of the output speed can be.

7. The mixing material must be continuously added in the hopper to ensure the continuity of the spray.

Spray work to be suspended, press the stop button can be, can make the operation more convenient, you can use the following methods for remote control: the middle of the box to the left is the manual control switch.

8. Spray work before the end of the hopper to be left after the material spray, close the air pump, after the shutdown.

9. Remove the gun and remove the parts one by one clean.

10. In the hopper into the water, press the pump to clean the pump. When the nozzle flows out of the clear water, press the button to stop, remove the delivery hose and roll up