How To Use CozySculpt ®
--
Here's a step by step guide
--
1.Puncture
a hole into the skin
The
gauge of the sharp needle needs to be
slightly superior to the gauge of the
microcannula in
use.
>The 30G & 27G cannulas come
packaged with a 26G sharp needle
>The 25G cannulas come packaged
with a 23G sharp needle
>The 22G cannulas come packaged
with a 21G sharp
needle
TIP:
Use the length of the Microcannula as a
point of reference to where to make the
hole.
2.insert the tip of the Microcannula into
the skin
>Insertion of the tip of the
microcannula should be from a 60 to 90
degree angle until the correct depth has
been found.
>Pinch the skin to create a small
drop of blood out of the puncture hole
which should help you locate the
hole.
>Stretch the skin opposite
direction with the non-injecting hand to
help enlarge the puncture hole.
>Place the index finger of the
injecting hand close to the tip of the
microcannula to help guide the cannula into
the skin,or hold the syringe like a
dart.
TIP:
If you want to remain superficial, by
pushing the cannula against the skin, The
cannula bends and the tip goes back
up.
3.Slide the CozySculpt ® Microcannula
into the skin
As
you are entering the skin, rotate the
cannula tangentially to the skin surface
using the flexibility of the
microcannula.
TIP:
If any resistance is encountered, go back
and forth without
forcing.
4.Inject filler in a retrograde
fashion
Start
injecting while pulling the length of the
microcannula in and out of the skin. To
change direction, pull the cannula out of
the skin almost entirely, back to step two
(leaving the tip at the desired
depth).
TIP:
You can fan the area 360 degrees around the
hole.
Massage
It's
recommended to massage the skin after the
injection to make sure the filler has been
evenly
distributed.
Member's Area
Messages 
Need Help
Browse Through Millions of High-Quality Products. 