Taper Block Sets

Product Details

Attentions given by positioning component supplier who wholesales high quality positioning component:

　　Remember the following points as you position multiple components:

　　• All the components are positioned together without any relative movement between one another.

　　• You can define constraints for multiple components in the same manner as you do for a single component.

　　• You can add one or more components for positioning even as the Position tool is active. The added component immediately gets the transformation that the other components are sharing.

　　• If you have selected 2 or more components for positioning, you cannot deselect any of them until they are positioned.

　　• You can move and reposition multiple components as one unit using the handles of the dragger. While dragging a linear handle, you can snap the components to a geometric reference and constrain them.

• If you add one or more components to a positioned multiple component set, any constraints that were applied earlier while positioning the components are cleared.Material

Material Hardness Heat Treatment

YK30 HRC56°~60° Vacuumed

For more product details, please refer to the Positioning component page：https://www.jh-mouldparts.com/product/positioning-components/