Model NO. | TL-HIT-CH | Size | Prismatic |
Certification | PSE, RoHS, TUV, CE | Socket Type | For USA/Canada |
Recyclable | Recyclable | Transport Package | Paper Box |
Trademark | no | Origin | Shenzhen China |
HS Code | 850440999 | Production Capacity | 5000 |
1)tool battery charger for
HITACHI 7.2V~18V batteries
2) For Ni-CD,NI-MH li-ion battery
3)Universal volt:110V-240V
Power Tool Battery Charger for Hitachi UC14YFA UC18YG UC18YRL UC24YFA UC7SD UC9SD
1) Cordless power tool battery charger suit for HITACHI 7.2V~18V batteries
2) GD-HIT-CH01
3) Suit for HITACHI 7.2V~18V Ni-CD, Ni-MH and Li-ion batteries; Including external adaptor as power supply (Universal voltage: 110V-240V)
4) One Year Warranty
5) CE ,ROHS certificate
6) Can also charger the for HITACHI Original Battery
Specification:
Output Voltage:
7.2-18V
Input Voltage: 110-240V
Replace Original Charger Code:
UC7SB UC7SD UC9SD UC12SD UC14SD UC14YFA UC18YG UC18YRL UC24YFA
CHARGING METHOD INTRODUCTION
1. Lithium-ion Battery Charging
Method:
When the charger detected the voltage of the
Li-ion battery mounted onto the charger is less
than 3.0V/cell, it will use 450mA current test
charged the battery. Should the voltage of the
battery can not increased to over 3.0V after 30
minutes of continuous trickle charging, the
charger will consider this battery a bad one. For
normal battery charging, the charger will use
3A/2A/1.5A to charge the battery and it will
continuously monitor the batterys temperature /
current / voltage. Once the preset quick charge
time is up or the preset current value is
reached, the charger will automatically reduce it
charging current to 0.3A and its LED indicator
will switched to FULL CHARGE state. But it will
not stop slow charging until the preset 30
minutes time have lapse or the charging current
is reduced to less than 100mA, then the battery
is considered as fully charged and the charging
is terminated.
Max. Charging Time: 2.5 hours
Voltage Error Detection: Less than 4V or higher
than 26.5V
Trickle Charging: when <3.0V/cell, charging
current approx 450mA
Trickle Charging Time: 30 minutes
2. NIMH Battery Charging
Method:
The charger will quick charge the battery at
constant maximum current and preset time, and
continuously monitor the -dV/dT signal and
temperature condition of the battery. Once a
-dV/dT signal is detected, it will change to the
slow charging for another 30 minutes. Then the
charging process will stop and the battery is
considered fully charged.
Max. Charging Time: 2.5 hours
Over-temperature Limit: 47.5 degree Celcius.
-dV/dT Measurement: After a negative voltage
change (the smallest unit value) is detected and
followed by 2 consecutive detections of no
voltage increase, a -dV/dT is established. The
negative value is the smallest unit value of
27mV.
LED
Description:
1: Standby…green LED flashing @ 2HZ
2: Trickle charging…red LED flashing @ 2HZ
3: Quick charging… red LED glow steady
4: Fully charged…green LED glow steady
5: Reversed-polarity battery, Bad Battery…red LED
flashing @ 1Hz