MOQ | 1 set |
Port | QINGDAO |
Packaging | Wooden Case Packing |
Lead Time | 14days |
Short-Circuit Impedance(%) | 4, 4.5, 6.5 |
Product
introduction
This product
conforms to the national standard gb1094.1-2013 power transformer
and GB / t6451-2015 three-phase oil-immersed power transformer
technical parameters and requirements. This product has adopted a
series of major reforms in material, technology, and structure so
that the electrical performance of the product can reach the
advanced level of similar products. With the characteristics of
high efficiency and low consumption, it can save a lot of power
consumption and operation costs and has remarkable social
benefits. It is a new product promoted by the state. It is also
one of the more popular products for users.
2.Main Functions And
Features
1.
The low-voltage winding is of cylindrical or spiral structure,
with high mechanical strength and good short-circuit
resistance.
2.
The corrugated oil tank is adopted to replace the oil
conservator. The oil tank cover and the oil tank are all-welded
along the edge or fastened with bolts, thus prolonging the
service life of the transformer oil.
3.
After oil removal, embroidery removal, and phosphating treatment,
the product is sprayed with three times of primer and one time of
finish paint inside and outside. The product is salt fog proof,
damp heatproof, and fungus proof, which can meet the special
requirements of metallurgy, petrochemical system, and wet and
polluted areas. It is beautiful and
reliable.
4.
The transformer oil tank is fully sealed, and equipped with
pressure reducing valve, signal thermometer, gas relay, etc
according to the standard requirements to ensure the safe
operation of the transformer.
5.
This series of products are beautiful in appearance, small in
size, and can reduce the installation area. It is an ideal
maintenance-free distribution product.
Conditions of
Use
1.The maximum ambient air temperature shall not
exceed 40°C, and the minimum shall not below
-25°C;
2.The altitude shall not exceed 1000m. If
specially customized transformers and low-voltage components are
used, the altitude can reach 4,000m;
3.The vertical inclination is no more than 5°,
and no violent vibration and impact;
4.The air humidity is not more than 90%
(25°C);
5.No gas and conductive dust that will
seriously affect the insulation of the transformer, no explosion
hazard and corrosion of electrical components;
6.Outdoor wind speed shall not exceed
35m/s;
7.If service conditions beyond the above, a
specially customized product is available.