MOQ | 1 Piece |
Port | Nanjing, Shanghai |
Packaging | Wooden Box |
Lead Time | 7 working days |
Electromagnetic Flowmeter
Electromagnetic Flowmeters are the best solution to measure conductive liquids with minimum conductivity of 5μS/cm, as they offer rapid response time, high measuring accuracy and long term stability.
Suitable Diameter
DN10~DN2600 (below DN25 non-standard,which should be customized)
Electrodes Materials
316L (stainless steel), Hastelloy C, Hastelloy B, Titanium, Tantalum
Suitable Fluid
Liquid with conductive ratio more than 5 μs/cm
Measuring Range
0.1~10m/s (extendable to 15m/s)
Upper Limit of Span
0.5~10m/s. 1~5m/s recommended
Accuracy
0.3%, 0.5%,1.0%
Output Signals
4~20mADC, load<= 750ohm, 0~3kHz, 5V with source and changeable width.
high terminal and effective frequency output , RS485 interface
Operation Pressure
1.0MPa, 1.6MPa, 4.0MPa, 16MPa (special)
Fluid Temperature
-20C~80C, 80C~130C,130C~180C Depending on Lining Material
Ambient Temperature
Sensor -40C~80C. transducer -15C~50C
Ambient Humidity
<= 85%RH (at 20C)
Cable Outlet Size
M20(16) ×1.5,1/2”NPT
Power Supply
220VAC±10%, 50Hz±1Hz, 24VDC±10%
Power Consumption
<=8W
Protection Ratings
Integral type: IP65. remote type: sensor IP68,transducer IP65
Materials of Liner
PTFE, soft rubber, hard rubber, PFA, etc
Process Connection
Flange :ANSI , DIN , JIS ,ISO ,GB standard
Thread :NPT ,BSP ,G
Tri-clamp connection
Earthing Materials
316L (stainless steel), HC, Ti, Ta, Cu