Cation polyacrylamide for water treatment

Product Details

Polyacrylamide, abbr. PAM, is a kind of water soluble polymer,It is most often used to increase the viscosity of water (creating a thicker solution) or to encourage flocculation of particles present in water. Cationic Polyacrylamide, copolymerized by cationic monomer and acrylamide, is a wafer-soluble and linear organic polymer with high molecular weight.

Specificaion：

Application：

1. It is mainly used for the sludge dewatering and decrease the rate of water content of sludge.

2. It can be used to treat industrial wastewater for Sugar Making，dyeing and life sewage water

3.It also used for treatment of wastewater of paper industry，to improve dry and wet strength of paper  to increase

the reservation of tiny fibers and fillings.

4.Drinking water treatment

Application Method:

1. The product should be prepared for the water solution of 0.1% as concentration. It is better to use neutral and

desalted water.

2. The product should be scattered evenly in the stirring water, and the dissolving can be accelerated by warming the

water (below 50℃)

3. The most economical dosage can be determined based on a preliminary test. The pH value of the water to be

treated should be adjusted before the treatment.

Being used, PAM should be dissolved in solution of 0.1-

0.2%. If not use the matched dissolving and dosing system, a solution should be put in the diluted cans. Practice on 

machine via screw pump and adjust the amount according to the actual situation.

Package and Storage:

1. The solid product can be packed in inner plastic bags, and further in polypropylene woven bags with each bag containing 25Kg.

2. This product is hygroscopic, so it is should be sealed and stored in a dry and cool place below 35°C.

3. The solid product should be prevented from scattering on the ground because the hygroscopic powder can cause slipperiness.

Advantage：

★Good water solubility, it can be completely dissolved in cold water.

★ It can keep to greatly flocculation adding a small amount of cationic polyacrylamide products. Usually just add 0.0

1 ~ 10ppm (0.01 ~ 10g / m3) in order to make full use of.

★Using of cationic polyacrylamide products with inorganic coagulant

 (ferric sulfate, chloride, iron salts, etc.) may show greater effects.