72v 3000w electric four-wheel car, tricycle high power DC brushless motor dual mode 36 tube controller

72v 3000w electric four-wheel car, tricycle high power DC brushless motor dual mode 36 tube controller

Basic data of the controller

1. The thick black line of the power cord is connected to the negative pole of the power supply, and the thick red line is connected to the positive pole of the power supply. (Note: customers should not reverse the short circuit)

2. The red bullet interface of the electric door lock line is connected to the vehicle electric door lock switch. Note: When unlocking, the electric door interface and the positive pole of the power supply (the red main line of the controller) remain in the conduction state. 3. The phase line is thick yellow and thick blue and thick green three-phase line, connected to the motor.

4, Hall line black red yellow green blue five thin line combination interface, even the motor. Red is the positive pole of the Hall power supply, black is the negative pole of the Hall power supply, and yellow, green and blue are the Hall type lines. Note: The color corresponding to the color is required when the controller Hall line and the motor Hall line are connected.

5, turn the line (speed control throttle) black red green three thin line combination one word port connection speed governor, red for the turn power supply positive (voltage value 4.3V or so) black for the turn voltage negative (ground), green Enter the signal for the turn.

6. Inverted parking line (otherwise, the gear line) (advanced neutral gear reversing) black and white blue three thin wire combination interface, the three wire keeps disconnecting the motor forward, fine black and fine white short is the neutral (power off) fine black and The thin blue short motor is reversed. The customer can adjust the gear position according to different gears.

7, reversing speaker thin blue line interface

8, high battery broken wire (high level) fine yellow independent interface. When the vehicle brake signal is the power positive signal (high level) input, the controller stops working.

9. Ordinary instrument line (code table speedometer) The wiring harness of the green bullet is the instrument line. The customer can use the vehicle according to the actual use.

10, low battery broken wire (low level) fine black and white combination interface. When the brakes are connected to the black and white wires, the controller stops working.

11, Hall instrument line (fine purple)

12, phase identification line (also known as the learning line. Yellow color male and female two lines) to plug and learn, the motor works when learning, the first-time learning reverse, after disconnecting again, it is forward The learning time is one minute and the most stable. Note: The tires can be docked after being suspended. After docking, click on the self-running identification. Do not insert them at will. Single mode does not have this interface.

13. The soft and hard start line is disconnected from the soft start, and the start is relatively flat. Docking a hard start, starting relatively quickly. (Some models do not have this interface)

14. The alarm line (blue, yellow and gray thin line) is connected to the alarm.

15, alarm power cord (black red thin line)