Hontop Special Vehicle Co., LTD

Quality Control

Quality control

We have strict quality control process. We divide our quality control into four inspection stages - IQC, IPQC, FQC, OQC. Each product type has a different quality control standard to ensure they meet strict requirements. Our QC Team is composted of educated professional that have years of experience in the QC field. Our quality control goal is: no defective vehicle manufactured, no defective vehicle shipped.

 Incoming Quality Control - IQC

All incoming raw material including the chassis, steel plate, carbon steel, valve, pump, etc. are checked before used. Varies measurements are taken to check against approved data. Once rejected, raw material are sent back for further examination.

In Process Quality Control - IPQC

We perform inspections during the manufacturing process. Frequency of inspection depends on the quality standard set forth by the project. All manufacture data is recorded for future reference

Final Quality Control - FQC

All finished trucks are inspected according to our quality standard for each project. Vehicle must meet the   AQL sampling standard before it leaves our manufacture plant into the warehouse

Outgoing Quality Control - OQC

Our QC team will randomly check any finished vehicle in the warehouse before it goes out for shipment. This last inspection ensure zero inferior-quality vehicles are shipped to our customer.

 Proper Quarantine Procedure

Rejected material are specially marked and move to a quarantine area pending final disposal. Once a vehicle is deem rejected by the QC team, the material is hold until further inspection. Our QC team have right to stop a shipment if vehicle doesn’t meet standard.

Complete Complaint Procedure

All complaints are traceable through our QC system for up to 1 year. Each complaint is follow up with further corrective action by manufacture. Complaints trends are further analysis monthly for further action

 Acceptable Quality Level

We use a strict Acceptable Quality Level measurement for all our vehicle. If the AQL is not reached, we will review various parameters in the manufacturing process to determine the areas causing the defects.