Product Details
PRODUCT DESCRIPTION
AOSION SOLAR ANIMAL REPELLER FOR CAT DOG DEER FOX BIRD AN-B030:
-
100% ECO-Friendly
-
NON-CHEMICAL
-
IPX4 Waterproof
-
No harm to human or pets
-
Patent Number: ZL.2012 30300821.9
1. A strong ultrasonic signal frightens animals. The animals
avoid the area because of its unpleasant ultrasonic sound. The
sound is activated when an animal enters the range. Thus,
animals cannot get used to the sound, and the repulsive effect
is stronger.
2. A strong flashing scared animals. The strong flashing is
activated when an animal enters the range, then the animals
will be scared and give back..
BUTTON "FREQ" POSITION:
13.5kHz-17.5kHz Repels animals such as mice, small rodents ...
15.5kHz-19.5kHz Repels animals such as large dogs, foxes ...
19.5kHz-23.5kHz Repels animals such as small dogs, cat, bird,
bat ...
Strong flashing
All function working, sweep frequency from mode 1 -- mode 2 --
mode 3, and turn on strong flashing
Warnning(Top
Important)!!!
Battery Instructions
Step 1. When using the device for the first time, please use the
device till the power(built-in batteries) is to the lowest: when
the red low-voltage indicator will keep blinking or there is no
reaction after turn-on the device.
Step 2. Connect the device to a standard USB output out, and use
the USB cable in packaging charge the device for 6-12 hours:
2.1: Because of the different power and voltage output by
different USB and different activity of batteries, it's normal
that the red indicator may keep flashing after charing for more
than 12 hours(the device could be used normally even charging is
stopped), please just install the device in a normal usage
scenario and use it would be OK.
2.2: If the charging time is significantly less than 6 hours, but
the indicator kept light up(showed charging finished, not
flashing), please continue to charge for at least 6 hours.
Step 3. If the red indicator keeps flashing or the device stop
working without any response after using for some time, please
repeat Step 2., charge 6-12 hours, after 3-5 cycles of charge and
discharge, the charge and discharge characteristics of the
batteries would be stable and the charging index tends to be back
to normal.
Step 4. Please do follow the
three steps above
to enable the batteries in the device to maximize their best
performance.
SUITABLE ENVIRONMENT:
Do not use
the device in any extreme environment.
Otherwise,
important components of the device may be damaged or stop
working.
Solar panel: air salinity NO more than 3%; Applicable
temperature: -20℃ ~ +85℃
Ni-Cd battery applicable temperature:
-10℃ ~ +45℃ (over -10℃ ~ +50℃ can’t be charged, over -20℃ ~
+60℃ can’t output power)
Ni-MH battery applicable temperature:
-18℃ ~ +65℃ (over 0℃ ~ +55℃ can’t be charged, over -18℃ ~ +65℃
can’t output power)
Please dispose the batteries according to the your
country's laws and regulations.