INR18650-2200mAh battery,2000mAh Li-ion battery supplier

MOQ	2000 PCS
Port	SHANGHAI
Packaging	CARTON BOX
Lead Time	30-45DAYS

Contact Now

Product Details

INR18650-2200mAh battery,2000mAh Li-ion battery supplier,lithium ion battery for power tool,power tool lithium ion battery supplier

Safety Characteristic of bicycle 18650 battery

NO.	Item	Standard	Test Method
1	Overcharge	No fire、No explosion	After standard charge, rest for 10mins; then charge at constant current of 3C5A to 10V.(or charge at 3C5A for 90mins).
2	Forced discharge	No fire、No explosion	The battery to be discharged with standard discharging condition, Inverse charge current =1C5A；time: ≥ 90mins
3	Short Circuit test	No fire、 No explosion	The battery to be fully charged with standard charging condition, and short the positive and negative terminals with wire resistance ≤50mΩ.Tests are to be conducted at 23℃±3℃ and at 55℃ ±5℃, keep 24h or case temperature decline to 20% of the max temperature ,test is over.
4	Crush test	No fire、No explosion	A battery is crushed between two flat surfaces. The applied force is 13 kN±1kN by hydrocylinder, Once the maximum pressure has been obtained or voltage decrease to 1/3 of nominal voltage sharply, then release pressure.
5	Shock test	No fire、No explosion	The full charged battery is fixed on shock table, to force a certain shock to three mutual vertical direction, in initial 3ms, the min. average acceleration is 75gn,the peak acceleration is between 125gn and 175gn.
6	Heating test (130°C)	No fire、No explosion	The cells are fully charged with standard charging condition, and put into incubator with nature air or cycled air convected, heat battery by velocity of 5°C ±2°C/min to 130°C±2°C,and maintain for 10mins.
7	Temperature Cycling Test	no leakage, no fire, no explosion	The fully charged batteries are placed in a test chamber and subjected to the following cycles: a) Raising the temperature to 75°C ±2°C within 30 minutes and maintaining this temperature for 6 hours. b) Reducing the temperature to minus 40°C ±2°C within 30 minutes and maintaining this temperature for 6 hours. c) Repeating the sequence for a further 9 cycles. d) After the 10th cycle, storing the batteries for 24 hours prior to examination.

Warnings and Cautions in Using the high quality car 18650 battery

To prevent a possibility of the battery from leaking, heating or explosion please observe the following precautions:

● When using a new battery for the first time or after long term storage, please use the battery charger specifically for that purpose fully charge the battery before use.

● Do not disassemble or open, crush, bend or deform, puncture, or shred;

● Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or expose to water or other liquids such as water, seawater, drinks such as soft drinks, juices, coffee or others, or expose to fire, explosion, or other hazard.

● Do not short circuit a battery or allow metallic or conductive objects to contact the battery terminals.

● Avoid dropping the phone or battery. If the phone or battery is dropped, especially on a hard surface, and the user suspects damage, take it to a service center for inspection.

● The battery replacement shall be done only by either cells supplier or device supplier and never be done by the user.

● Replace the battery only with another battery that has been qualified with the system per standard. Use of an unqualified battery may present a risk of fire, explosion, leakage, or other hazard.

● Don't keep a battery at rest for a long time (over 6 months). Safety accident may happen when recharging battery which has a rest for a long time.

● In the event of a battery leak, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected area with large amounts of water and seek medical advice.

● Battery usage by children should be supervised. Seek medical advice immediately if a battery has been swallowed

● Never disassemble cells. The disassembling may generate internal short circuit in the cell, which may cause firing or other problems.

● Never incinerate nor dispose the cells in fire. These may cause firing of the cells, which is very dangerous and is prohibited.

● Do not remove the outer sleeve from a battery pack nor cut into its housing.

● Do not mix our batteries with other battery brands or batteries of a different chemistry such as alkaline and zinc carbon.

● Do not mix new batteries in use with semi-used batteries, over-discharge may occur.

● Promptly dispose of used batteries in accordance with local regulations.

Ship

The cells might be damaged during shipping by shock. If any abnormal features of the cells are found such as deformation of the cell package, smelling of an electrolyte, an electrolyte leakage and others, the cells shall never be used any more. The Cells with a smell of the electrolyte or a leakage shall be placed away from fire to avoid firing.

The company founded in 2014, focus on producing cylindrical power lithium-ion batteries. The company supply Electric vehicle cylindrical lithium battery, which include 1500mAh, 1300mAh, 2000mAh, 2200mAh, 2500mAh, 2600mAh Li-ion battery and 3000mAh Li-ion battery. All adopt the most advanced extrusion coating production technology and yearly production reaches to 250 million Ah power type 18650 High security lithium ion battery. Our products have high quality and competitive prices.

If you want to learn more about the High security lithium ion battery, please visit here.

https://www.sp-powerbattery.com/